Hopkins 43105 plug-in enkel fordonskabelsats

Brand:‎Hopkins Towing Solutions

3.6/5

68.47

Som det främsta varumärket inom bogsering av elektriska produkter har Hopkins Towing Solutions försett konsumenter med innovation, hållbarhet och prestanda i över tjugo år. Med Hopkins T-kontakter behöver du inte skära i ditt fordons ledningssystem. Detta är snabbare och enklare än att skära och skarva och kommer att hålla integriteten hos ditt fordons ledningssystem intakt.

Ingen skärning, lödning eller tejpning. Enkel installation i 4 steg. Det tvådelade systemet ger en mer mångsidig installation samt ett enkelt alternativ för att byta kontakt om enheten någon gång skulle skadas. Förkopplad för att ge högersväng, vänstersväng, bakljus och på vissa modeller backup-funktionen. T-kontakter gör att du kan ansluta din trailers ledningssystem till ditt fordons ledningssystem.
Brand ‎Hopkins Towing Solutions
Country of Origin ‎USA
Customer Reviews 4.6 4.6 out of 5 stars 287 ratings 4.6 out of 5 stars
Exterior ‎Smooth
Is Discontinued By Manufacturer ‎No
Item model number ‎43105
Item Weight ‎7.2 ounces
Manufacturer ‎Hopkins Towing Solution
Manufacturer Part Number ‎43105
OEM Part Number ‎43105
Product Dimensions ‎8.88 x 3.88 x 1.88 inches

3.6

11 Review
5 Star
77
4 Star
12
3 Star
3
2 Star
5
1 Star
3

Skriv din recension

Din e-post kommer inte att publiceras. Alla obligatoriska fält är markerade med*

Scritto da: chkywuky
Light adp
Expensive
Scritto da: brian larson
Fit my Tacoma perfectly
It only took a few minutes to install.
Scritto da: Melissa Robinson
Works perfectly
Was a pleasure using this product fit exactly as expected and came with all mounting hardware great product and great company only wish it had some propaganda for my truck window
Scritto da: Steve
fits my 96 Honda
easy to connect
Scritto da: dig
no good installation instructions
I installed this product on a 04 Honda Element and it will need an extension to reach over the tail gate to a trailer. you will need to remove the right rear seat and unbolt the seat bracket. ( 3 bolts ) you also need to take the seat belt bolt out. take out the screws that hold the interior out and pop off the piece by the seat belt, rear strut plus a corner piece that would be behind the seat. I pried up the molding at the bottom of the door just enough to get the side piece clear. slowly and carefully work you way back from the side door to the rear, if things don't move you might have missed a screw. once the side piece is loose the plug is to the rear and lay the wire under the side piece into the spare tire well. Make sure the doors weatherstrip is on the outside of the plastic when you put it back together. Take your time and don't use too much force.
Scritto da: S. Vaden
Hopkins trailer taillight converter 43105
These adapters convert the five wire taillights of your car to four wire taillights of the trailer. The circuit is actually kind of complicated, but it is sealed inside the housing so it cannot get wet. The only problems I had installing this on the CRV were not related to the harness itself. You have to remove the inner plastic panel on the driver's side to get to the taillight connector, then you have to enlarge the hole in the bottom of the inner fender so that the taillight converter connector can fit through. I used a Unibit drill bit to enlarge the hole, and found a rubber grommet to fit so that it would not wear through the wires. The converter housing can be attached under the car with supplied tie wraps. These days ROHS requires the elimination of lead in connector platings. The plating used on the bullet connectors soon develops a white oxidation that makes it hard to plug the connectors together. The tin/lead platings were much better because they supplied some built-in lubrication. One step forward for mankind, two steps back. SV
Scritto da: Jesus O.
Good product
Facil de installed
Scritto da: crystal
Perfect for non led set up
Works as it should. However if you are running leds this is not the module you want to use. The module back feeds a little which will cause a led to light up when it shouldn’t where as a regular bulb won’t.
Scritto da: working class drone
Fits 2003-2004 honda element
fits perfectly into factory honda wiring harness. no cutting wires / splicing etc. hooked up the trailer and all the lights work flawlessly. i have read this does NOT fit the 2005+ honda element
Scritto da: Tanner
100% recommend!!!
Works as described, comes as described, plug n play
Scritto da: Vincent
Perfect!
Did wath is supose to. Perfect!

Relaterade produkter

Upptäck vårt internationella nätverk

Vi skickar till 28 länder, över 200 000 produkter. Håll dig uppdaterad, prenumerera på nyhetsbrevet.

Array