Små delar Mässing platt bricka, slät finish, DIN 125, metrisk, M3 skruvstorlek, 3,2 mm ID, 7 mm OD, 0,5 mm tjock (pack med 100)

Name: Små delar Mässing platt bricka, slät finish, DIN 125, metrisk, M3 skruvstorlek, 3,2 mm ID, 7 mm OD, 0,5 mm tjock (pack med 100)
Brand: Small Parts
Price: 30.55 EUR
Availability: InStock

Brand:Small Parts

3.4/5

€
30.55

Uppfyller DIN 125 specifikationer. Vanlig yta har ingen finish. Mässing ger korrosionsbeständighet och ger termisk och elektrisk ledningsförmåga. Platt bricka ger en lageryta för fördelning av fästelementets belastning eller fungerar som ett distanselement.

Belopp

Lägg till i kundvagn Köp nu

EAN:

Kategorier Industri & vetenskap, Spikar, Skruvar & Fästelement, Växlar, Platta brickor,

Exterior Finish	Brass
Fastener Size	M3
Material	Brass
Outside Diameter	7mm Millimeters
Washer Type	Flat

5 Star

4 Star

3 Star

2 Star

1 Star

Skriv din recension

Din e-post kommer inte att publiceras. Alla obligatoriska fält är markerade med^*

Ditt betyg

Scritto da: V T

Shorted and Defective

I only received 93 1/2 out of 100. One was cut in half, one was 1mm thick, some were nipped on the edge or cut through the ring on one side. I needed all true 100 pcs for my project. I will not buy from a seller who shorts the quantity to make you buy more to increase their profits.???? Amazon customer service helped me with this problem.☺

Scritto da: Amazon Customer

Four Stars

A little smaller than I was expecting.

Scritto da: Bob L.

Four Stars

Slow shipping but they work fine

Scritto da: Alex Croy

Five Stars

It's a package of washers! Exactly as described! I deeded these for a very specific purpose.

Scritto da: fiatowner

Five Stars

Exactly as advertised, which is what you really want for these kinds of parts.

Scritto da: Ernest Ray Jones

Five Stars

great

Scritto da: El Capitan Asombroso

Good deal for money, expect to do a little work.

For the price, these are a great value for the money. That said there are some issues: my pack had several miss-struck washers that were unusable, there was clearly no finish tumbling as these have burrs and strike flashing. I bought these to use as carburetor needle shims, but I will need to clean up and tumble them before I install them since the thickness isnt uniform.