0
0

CURT 55326 ajoneuvon puoleinen mukautettu 4-nastainen perävaunun johtosarja, sopii tiettyihin Ford Crown Victoria, Ford Mustang, Mercury Grand Marquis, musta

Brand:CURT

3.3/5

70.29

Jos ajoneuvossasi ei ole perävaunun vetämiseen tarkoitettua johtoa, CURT mukautettu johdotus on ihanteellinen ratkaisu. Mukautettu johtosarja, jota kutsutaan myös T-liittimeksi, on yksinkertainen, plug and play -sähkölaite, joka liitetään autosi sähköjärjestelmään ja tarjoaa tavallisen, yleisen perävaunun johdotuksen. Tämä tehdään käyttämällä kahta tai useampaa ajoneuvokohtaista, OEM-yhteensopivaa liitintä, jotka liitetään takavalokokoonpanoon, mikä eliminoi tarpeen leikata, jatkojalostaa ja juottaa asennuksen aikana. Mukautetut johtosarjat on tehty ajoneuvokohtaisesti, ja vaikka niitä ei ole saatavilla kaikkiin ajoneuvoihin, ne tarjoavat yhden nopeimmista, helpoimmista ja turvallisimmista tavoista kytkeä ajoneuvo hinaukseen. Tämä erityinen pistokesarja sisältää 4-suuntaisen litteän pistorasian, ja se on suunniteltu mukautetuksi johtosarjaksi, joka sopii tiettyjen vuosien Ford Crown Victoria-, Ford Mustang- ja Mercury Grand Marquis -malleihin (varmistaaksesi ajoneuvosi yhteensopivuuden, katso sovellustiedot). . Sen mukana tulee kaikki tarvittavat johdotuskomponentit luotettavan perävaunun johdotuksen muodostamiseksi sekä pölysuoja, joka pitää liittimen puhtaana, kun sitä ei käytetä. Sinulla on mielessäsi kuva seuraavasta määränpäästäsi – ehkä se on suosikkikalastuspaikallesi laskeutuva vene, ehkä se on leirintäalue, josta on näkymät yhdelle luonnon mestariteoksesta, tai ehkä se on seuraava suuri työmaa. Tämän kuvan muuttaminen todellisuudeksi vaatii kuitenkin muutakin kuin pelkkää haaveilua. Se vaatii kiinteän yhteyden ja oikean määrän tehoa. CURT mukautettu johdotus on tehty alan kehittyneimmällä tekniikalla, ja se on suunniteltu asennettavaksi helposti, mikä antaa sinulle pitkäaikaisen sähköliitännän vetokoukun asennukseen.

PÖLYSUOJA. Tämä 4-napainen perävaunun valaisimen johtosarja on varustettu kumisella pölysuojalla, mikä edistää pitkäkestoista käyttöä ja säänkestävyyttä. Se sopii helposti 4-suuntaiseen litteään liittimeen, kun sitä ei käytetä, suojaten sitä ulkoilman vaikutuksilta. HELPPO OTTO. Perävaunun johtojen ja perävaunun valojen kytkeminen on helppoa tämän ajoneuvon pistorasian ergonomisen suunnittelun ansiosta. Sen ylä- ja alaosassa on kielekkeet, jotka tarjoavat paremman otteen, kun kytket perävaunuun tai irrotat sen. AJONEUVOKOHTAISET. Tämä jälkimarkkinoiden ajoneuvoperävaunun johtosarja on suunniteltu Ford Crown Victorian, Ford Mustangin ja Mercury Grand Marquisin tiettyihin vuosiin. VAKIOLIITIN. Tätä 4-tasoista perävaunun johtoa voidaan käyttää yhdistämään perävaunun takavalot, jarruvalot ja suuntavilkut. 4-suuntainen perävaunun valojohdotus on suosittu useissa perävaunuissa, mikä lisää ajoneuvoosi monipuolisia hinausvaihtoehtoja. HELPPO ASENTAA. Ei leikkausta! Ei liitoksia! Tämä perävaunun johtosarja liitetään ajoneuvosi olemassa olevaan tehdasjohdotukseen ja on varustettu tavallisella 4-napaisella takaperävaunun johtoliittimellä perävaunun kytkemistä ja hinaamista varten.
Brand CURT
Brand ‎CURT
Country of Origin ‎USA
Customer Reviews 4.2 4.2 out of 5 stars 44 ratings 4.2 out of 5 stars
Is Discontinued By Manufacturer ‎No
Item Dimensions LxWxH 9 x 4 x 2 inches
Item model number ‎55326
Item Weight 0.49 Pounds
Item Weight ‎7.8 ounces
Manufacturer ‎Curt Manufacturing
Manufacturer Part Number ‎55326
Material Rubber
Model ‎Custom Wiring
OEM Part Number ‎55326
Product Dimensions ‎9 x 4 x 2 inches

3.3

9 Review
5 Star
60
4 Star
20
3 Star
10
2 Star
0
1 Star
10

Kirjoita arvostelusi

Sähköpostiasi ei julkaista. Kaikki pakolliset kentät on merkitty*

Scritto da: Romy
Easy to install, but the finished install is jank
Super easy to install, instructions are included but you basically just piggyback this into your rear lights. I think it took like 10 minutes on my 97 Crown Vic. It helps to have some sort of trim removal tool to pop off the plastic clips Ford used to hold the trunk trim up with. It works fine, didn't have to rewire it like some other folks said. Biggest issue I have (which is why it's 4 stars) is that it stays in your trunk until you need it. Like, loose in the trunk. The instructions say something with the gist of 'just sort of tuck it up out of the way someplace.' When you want to use it, you pull it out of the trunk, hook it up to the trailer, and just kind of close the trunk lid on the wires. It's not like the fit and finish on a mid-90s Ford makes this problematic (the wires don't get pinched at all), but it's just jank. They could have routed it through a body plug or something similar (albeit the wires are too short to go through any of the stock body plugs). I'll eventually properly mount this outside the car, but it's going to be a PITA since the connectors will have to be depinned, a hole will need to be drilled, and I'll need to route it all through a grommet that fits said hole. Totally doable, but it's going to take more than 10 minutes.
Scritto da: WEH
Works great!
Fits perfect on my 1995 mustang.
Scritto da: John T. Ertz
Easy to plug in, but was wired wrong.
Very simple to install as stated in the instructions, but as soon as I tested my lights my left signal started flashing fast as though a bulb was burned out, but it was also flashing the side marker light. Disconnected harness and all returned to normal. Broke out test lamp and found that the harness wires from this unit had been improperly placed. In the female connector that plugs to the vehicle wire harness, the Yellow (signal) wire is in the top right, with the Brown (marker lamp) wire in the bottom right. However on the male plug that goes to the taillight and sidemarker, the Yellow and Brown wires are reversed so that the Stop/Turn wire is trying to feed the side marker and the Brown side marker wire is trying to feed the Stop and Turn function. Might want to check that quality control at your Mexican plant and make sure the assembler isn't color blind...
Scritto da: IntoxicatedRedneck
Works
Arrived this evening, I was nervous to open anything from the mail at this point. However, I needed to go pick up my S-10, so I opened it up and found out the harness was real easy to install. I put this in my 96 Mercury Grand Marquis, it basically just snaps into the back of the tail light plugs on the both sides. Takes a minute, hooked up my car trailer, everything worked like it should. Picked up my truck, came back home, everything still works. Its a gud buy.
Scritto da: Yooper-in-gb
Curt 55326 wire harness
This device does not fit a 2004 Mercury Grand Marquis LS as stated on the Amazon parts selector. It only works up to 1997. Curt harness #58044 is for later models and must be spliced in. This(55326) harness just plugs in and looks like a great way to put on a trailer plug. I am sure it works great on the correct model cars. Note for Curt Mfg. - Amazon does NOT download directly from Curt what parts fit each model, so check the Curt site first for compatibility.
Scritto da: joshua
Nice
Work perfectly for mustang 94 convertible V6
Scritto da: Louis c.Brown jr.
Four Stars
thank u
Scritto da: David Plowman
Five Stars
I have not used it yet but think it well work
Scritto da: Amazon Customer
Great price
Quick and easy install

Liittyvät tuotteet

Tutustu kansainväliseen verkostoomme

Toimitamme 28 maahan, yli 200 000 tuotetta. Pysy ajan tasalla, tilaa uutiskirje.

Array