Groz 4-osainen tapirei'ityssarja

Name: Groz 4-osainen tapirei'ityssarja
Brand: Groz
SKU: 8901486267685
Price: 49.41 EUR
Availability: InStock

Brand:Groz

2.5/5

€
49.41

Messinkilävistimet ovat ihanteellisia pehmeiden materiaalien herkkään työhön. Ei-marring, ne eivät aiheuta vahinkoa työstettävälle materiaalille. Käytetään myös pehmeän alkuliikkeen tuottamiseen, kun teräslävistystä käytetään myöhemmin työn suorittamiseen.

Määrä

Lisää ostoskoriin Osta nyt

EAN: 8901486267685

Luokat Teollinen & Tieteellinen, Työkalut & Kodinparannuslaitteet, Kone- ja käsityökalut, Käsityökalut, Työkalut, Tappityöntöpistimet,

4-osainen sarja sisältää: 1/8, 5/32, 3/16 ja 1/4; Pakattu vinyylipussiin. 4 tuuman pituus pyöreällä varrella. 1-osainen rakenne, jossa teräsrunko ja messinkilävistys. Ei-marring: ihanteellinen pehmeiden materiaalien herkkään työskentelyyn, koska ne eivät vahingoita työstettävää materiaalia. Valmistettu kiinteästä messingistä.

Country of Origin	India
Item model number	26768
Manufacturer	Groz
Package Dimensions	6.81 x 4.09 x 1.42 inches; 9.52 Ounces

5 Star

4 Star

3 Star

2 Star

1 Star

Kirjoita arvostelusi

Sähköpostiasi ei julkaista. Kaikki pakolliset kentät on merkitty^*

Arviosi

Scritto da: THC2

Bad Quality Control from Groz

I had planned to give these punches as a gift, but what I received is not giftable so I plan to return them. For starters, the bottom seam of the plastic/vinyl pouch was ripped so when I picked up the pouch, all the punches fell out onto the table, leaving behind a few dings and one nice chip in the finish. But that's my fault: I should have opened them over the trash can instead. The punches themselves look like they were assembled into a set from individual punches that they had laying around the shop. A few of them are shiny and new, others look dull, like they've been sitting around for a while. The tapers and especially the knurling are different on each punch. The 1/8" punch looks like the knurling isn't even finished! It looks like it should have spent a bit more time on the lathe. Finally, the size markings/engravings on the ends of the punches are of various quality ranging from good (on the 1/16" and 7/32" punches) to illegible (on the 5/16") to meaningless on the 1/8" punch where it only reads "3 - 0", whatever that means. Taken as a whole, all these defects and oddities tell me that the quality control at Groz is poor these days. I'd be afraid they'd break with a light tap from a small plastic gunsmith's hammer and I certainly would not give them as a gift. So they are going back to Amazon unused and I am never thinking about Groz tools again.

Scritto da: Marc B.

Good quality and I like the longer ones for better hand possitioning.

Very good product!